Anyone who has mounted a TV at a fixed height knows the compromise that follows. What works perfectly from the couch turns into a neck strain when standing at the kitchen counter, and a mount set for family movie night rarely suits solo reading in bed. Perlegear’s AX1 Smart Adaptive Mount, unveiled at IFA 2026, treats that mismatch as solvable, building a wall mount that repositions itself instead of asking people to keep adjusting around it.
The AX1 relies on viewing-position sensing to figure out where someone actually is in the room, then shifts the screen’s height through a motorized lift to match. Sitting on the couch, standing near the doorway, or reclining flat on the floor all call for a different sightline, and the mount recalculates rather than leaving the screen locked in one static position that only serves one posture.
Designer: Perlegear
Multi-posture recognition sits at the center of how the AX1 behaves once it is installed. The system distinguishes between sitting, standing, and reclining, adjusting the screen height for each without requiring someone to fumble with a remote or manually crank a lever. It is the kind of adjustment that used to require moving furniture or squinting at an awkward angle, now handled quietly by the mount itself.
Multiple people sharing one living room rarely share the same ideal viewing height, and the AX1 accounts for that through custom user profiles. Each person can save their preferred height setting, so the mount remembers whether someone prefers the screen slightly lower for reading subtitles or raised higher for movie night on the couch. It turns a shared TV into something closer to a personalized display, without anyone needing to remount hardware.
Control options extend beyond the mount itself, reaching into the smart home setups already running in most living rooms. The AX1 responds to a companion app, voice commands, and gestures, with compatibility built in for Alexa and Google Assistant. Someone lounging under a blanket can adjust the screen without standing up, treating the mount like any other connected device on the network.
On the hardware side, Perlegear built the AX1 to fit TVs between 50 and 90 inches, pairing its motorized lift with a 10-degree tilt range and plus-or-minus three degrees of leveling after installation. That leveling detail matters more than it sounds, since most mounts get slightly thrown off during drilling and mounting, leaving screens tilted just enough to notice during a long viewing session.
None of this changes what people watch, but it quietly removes one more obstacle standing between a person and a comfortable view. A mount that moves with the room, rather than forcing the room to work around it, treats posture and viewing comfort as part of the actual design brief instead of an afterthought solved by a thicker cushion or a taller side table.
