While there are clearly some concerns still to be addressed, the core concept is, in my opinion, a solid step forwrd for home (and office!) power distribution and management.

On the topic of object or fluid insertion, I should think it would not be impossible – nor excessively expensive – to include a ground fault interrupt into the circuit for each room, or even each wall.

And actually, you could not use a single RAIL within each baseboard. Instead, just put a side-by-side chain of “sockets” for those adapters to slide into … and design the socket so that current is only active when an adapter is inserted. The placement of each adapter would not have to significantly change – except perhaps losing a couple centimeters worth of flexibility – and the overall convenience and utility of the system would still be preserved.

A mild concern I do have, that has not been mentioned (but might already have been addressed) is total load capacity for each rail or room … and a means od determining how much of that capacity is in use or available at one time.

It occurs to me, by the by, that if such a system were adopted globally … the days of international travellers needing different adapters could become a thing of the past. Just have each of the modules able to determine available power, and step it up or down as required, based on the nation in which said adapter was purchased. That is to say, if an EU traveler buys some of these for their iron, laptop, hair-drier, and so on … when staying in a U.S. hotel with this rail system available … just drop their EU adapters into the US rail, and voila … self-adapting current.

Finally, a suggested additional feature: the ability to tie the system (via wireless master units, perhaps) into a home computer network, and a house-wide power management program running on a computer, would be IMO an excellent addition. For vacationers, you would also have the benefit of using that program to semi-randomly turn lights, television(s), and similar thins on and off, to enhance the appearance that the property is stil occupied.

It’s the designer here, and I want to thank you for your interest and your comments.

Indeed, Ingress Protection, ‘Standard Finger’ compliance, earthing, safety devices, etc are all part of the design challenge, and we are confident all can be overcome to comply with the most stringent regulations in the world here in the UK.

Think about why it would be any different for a 3-pin or 2-pin socket (and the plethora of extention devices) in terms of safety?

The design of chased-in cabling and fixed access points hasn’t changed in many years, but safety devices to protect from a fault state have, which can enable electrical distribution to be taken into the 21st century.

Warm regards,
Ashley